|
Post by Daryl Payne on Aug 23, 2021 10:59:51 GMT -7
www.thingiverse.com/thing:4923281This link above is a pic of a spectator that I do not have on my track- it is 3d printing as i type this. It is a free file in "thingiverse.com" there is quite a bit of slot car related item. If you find any spectators and do not have acess to a 3e printer ( some libaries now have them) I could make a figure for you. I am not out to make any $. The amount of plastic I would use is so minimal that I would not need any thing for materials. A set up takes about 5 minutes. The specator I am makeing now supposidly is to take just less than an hour to run. If this spectator is readily avalable good. There are a lot of slot car things on "thingiverse.com", such as buildings, hot dog stand, outhouses, bridges some 3d chassis, pits and accesories. If you see something you like let me know. Like i said, i am not out to make $, but some of the items take a few hours to run, so $5 would hlep belay the wear and time spent. I can reduce or increase the scale size. Some of the items I have made were written (3d file made) in 1/24 but it is very easy for make it bigger or smaller e.g. 1/32 . Take a look and let me know Daryl
|
|
|
Post by Steve Burkey on Aug 26, 2021 7:19:07 GMT -7
I've been looking for a "cowboy" driver with hat; perhaps a clone of the Carrera guy? Or even just the hat in 1/32 or so. If he looks like Harrison Ford, all the better! (55 Chev from "American Graffiti")
|
|